Hydrosteel 6000 Models

The Hydrosteel Complete Kit is available under one convenient part number including both the low temperature and high temperature probes, giving you everything you need to begin monitoring active corrosion. Now with a 1 year Gold Replacement Service included you have total piece of mind that you will never be without an instrument.

Kit includes:

Hydrosteel 6000 analyser with leather jacket
1 years Gold Replacement Service
Hydrosteel 6000 user manual
Robust Peli field case to contain all components
LT-R probe for low temperature measurement
1 m and 2 m LT-R gas sample conduit
LT-R poles and swivel joint for extended reach
LT-R replacement places x 2
HT-R probe for high temperature measurements
2 m HT-R gas sample conduit
HT-R very HT conduit extension
HT-R replacement plates x 6
HT-R plate replacement wrench
HT-R plate fixing key
HT-R spanner (2)
IRDA link including power cables, mains adaptor, software and serial comms cable

Hydrosteel probes explained

LT-R probe The LT-R probe is a low temperature, roaming probe enabling spot measurements of flux within 60 seconds. It attaches to the steel magnetically, and with the aid of a strap for small pipes. The probe can be attached to steel surfaces as small as 3.5 inches in diameter and at temperatures up to 130 °C, 270 °F.
	HT-R probe The high temperature HT-R probe is 2.25 inches in diameter and magnetically attachable to the steel surface. It has been specifically designed for insertion into inspection ports. It can be applied to any steel surface greater than 8 inches in diameter and at temperatures up to 500 °C (930 °F).
AT-S probe The all temperature stationary probe has been designed for semi-permanent installation at a site and is attached using banding. The AT-S probe is ideally attached to sites requiring frequent monitoring, ensuring consistent measurements time and again. It can be fixed to any steel surface greater than 8 inches in diameter and at temperatures up to 500 °C, 930 °F.
	HT-S probe The high temperature stationary probe is a 2.25 inch diameter probe which is attached with banding to steel surfaces. The probe allows measurements at pipe bends and other curved areas where corrosion can be significant. This probe can be semi-permanently attached to any steel surface greater than 3.5 inches in diameter and up to 500 °C, 930 °F.